-
09:30
Кубок России, 10 км, масс-старт в гору, своб., жен.
-
10:55
Кубок России, 10 км, масс-старт в гору, своб., муж.
-
12:20
Кубок Содружества, 12.5 км, масс-старт, жен.
-
13:35
Биатлон с Дмитрием Губерниевым (12+)
-
14:20
Кубок Содружества, 15 км, масс-старт, муж.
Для начала небольшой ликбез.
Как уже обсуждалось на форуме, лыжи изготавливаются на заводе Амера. Скользяки и структуры OneWay’я.
Что касается лыж OneWay Premio 10 skate –
в магазине ТриалСпорт они представлены в двух вариантах – hard и soft. На каждой паре лыж присутствует наклейка с промером жесткости. Там указан диапазон веса, и два параметра – HBW и MF. По опыту атомика и саломона mf = вес лыжника/2 + 25.
По структурам – модель Premio 10 skate hard – структура (-5, -15), Premio 10 skate soft – холодная структура (-10, -30)
На сегодняшний день получилось так что в триале есть только Premio 10 skate hard во всех ростовках.
Это по коньковой линейке.
По классике – OneWay Premio 10 Classic Zero. Теплые лыжи, преваксед, для сложных условий.
Ниже информация от производителя по этой модели:
Zéro skis are optimal when it snowing wet and heavy snow and when there are large fluctuations in temperature. In these conditions the zero skis provide kick while normal kick wax ices up resulting in slippery skis.
Zéro skis are produced with a rubber inlay in the wax pocket zone, that needed to be prepared before skiing. Rubbing the base of the ski makes the hairs, which lie in the base material, stand up. These standing hairs provide the grip needed for wet/zero snow conditions. Coarser rubs will be required for more humid snow, i.e. wet, heavy snow. Finer rubs for aggressive snow, i.e. snow with lower humidity.
warning : The rubbed area stays ice free by corking in silicone or fluoro powders.
Glide zones must be waxed like for a normal classic ski.
whatyouneed :
• Sand paper 60, 80, 100, 120 grain
• corkor machine
• Liquid silicone, or fluoropowder
Instructions :
1. Start by wrapping a piece of coarse sand paper (60 or 80 grain) around a cork.
2. Rub the hardest part of the camber (under the binding) continue rubbing 15-20 cm forwards and backwards from this point.
Important: Make sure to remain in the centre of the ski with the coarsest sand paper, not rubbing too far towards the tip or the end. Rubbing too long from the centre will damage the glide zone and result in slower skis.
Rub the kick zone area of the ski several times to force the hairs to stand up. Repeat rubbing from both sides to create a cross pattern.
3. Switch to a finer sand paper (80-100 grain). Wrap the sand paper around the scraper or cork and work as described above. Start rubbing at the end of the coarse rubbing zone and work towards the ends of the special base material. Rub backwards and forwards.
4. Work the final 5-10cm on each end of the kick zone (special base material) with fine sand paper, 100-120 grain.
5. Rub silicone or fluoro powder by hand in the rubbing zone making sure to cover the entire kick zone.
If, when you try your ski they are sticky, the kick can be mellowed by using a finer sand paper (4 or 5 passes). If you need more kick, use a slightly coarser sand paper in the centre of the kick zone.
This method allows you to adjust your kick as you would with traditional kick wax.
Модели Premio 9 имеют более другую базу, и вес на 200гр выше(за пару) чем верхние модели.